Solar Diamond Dresser
» Single Point
Solar Diamond Dresser
Solar Diamond was started in the year 1982, with a
registered office in Mumbai and a factory in Ambernath.
From a small beginning it has grown well to cater home market and export
Solar Has a large network throughout - India, United States, Germany,
Italy, U.K., Middle East, etc.
Solar uses advanced technology in manufacture of our tools, with latest
machineries like induction heating machines, furnace, diamond lapping
Single point "bruted diamond" dressers are
made with selected "Congo Rounds" mounted in a matrix. A Single
cutting edge is presented to the grinding wheel.
Diamonds for single point dressers are selected in accordance with quality
and size. The question of using a superior, average or commercial quality,
depends on the grinding finish required and the machines and working
We offer three grades namely A, B & C for all the diamond size,
Availability: 0.25 Ct to 5.00 Ct
Natural Point Diamonds : The Diamond points are naturally formed.
(Not man made like grades A, B, & C) This is a gift of nature. Natural
Point Diamond Dressers have high form retention properties. Availability:
0.10 Ct to 2.50 Ct
Guideline for Single - Point Diamond Dressers :
Considerable care should be taken in mounting the diamond dresser in
position. Diamonds are sensitive to shock and impact.
The dresser must be clamped rigidly in place to avoid vibration once
An ample supply of coolant should be directed at the diamond point before
dressing begins, as the sudden application of coolant to the diamond once it
has heated up can cause it to shatter.
The diamond holder should not be set directly on the center of the grinding
wheel, but at an angle of 5-15 to the direction of rotation of the wheel so
that it appears to be "trailing"
At normal wheel peripheral speeds, dressing rates of approximately 20-25
m/sec can be achieved.
The maximum depth of cut achieved per dressing pass is 0.03 mm or on fine
grit wheels, approximately 0.005-0.01 mm. ( Single Point Diamond Dressers )
The cross feed rate is dependent upon grit size and can have a marked
influence on the quality of the finish imparted to the grinding wheel
surface. The lower the feed rate, the finer the surface finish. We would
recommend the following feed rates per revolution of the grinding wheel.
Diamond Dressers India
| Solar Diamond Tools Distributor |
Single Point Diamond Dressers Suppliers |
Diamond Cutting Tools Suppliers | India